|
|
Definitions from IC to Isolation Booth/ Isolation Room IC
Abbreviation of Integrated Circuit (A miniature circuit of many
components that is in small, sealed housing with prongs to connect it
into equipment).
Icon
A visual picture or symbol on a computer screen that represents a
file, program or disc that can be used.
ID
An index signal (digital data that gives the machine information of
where selections start, their selection number, etc.) on a DAT or CD.
IM Distortion
An abbreviation of the term Intermodulation Distortion (Distortion
caused by one signal beating with another signal and producing
frequencies that are both the sum and the difference of the original
frequencies present).
Images
The squaring of the waveform that happens in the conversion of
digital audio bits into analog signals.
Imaging
To make a representation or imitation of the original sonic event.
Impedance
1) A term for the electrical resistance found in a/c circuits.
Affects the ability of a cable to transmit low level (e.g. sound)
signals over a long distance. Measured in Ohms. Speakers are rated
according to power handling capabilities (Watts, W) and impedance
(Ohms).
2) The total opposition offered by an electric circuit to the flow of an
alternating current of a single frequency. It is a combination of
resistance and reactance and is measured in ohms. Remember that a
speaker's impedance changes with frequency, it is not a constant value.
3) The opposition to alternating current.
Impedance Matching
Having or converting the output impedance of a device so that it
matches the impedance of the input it will feed.
Inductance
The property of an electric circuit by which a varying current in it
produces a varying magnetic field that introduces voltages in the same
circuit or in a nearby circuit. It is measured in henrys.
Inductor
A device designed primarily to introduce inductance into an electric
circuit. Sometimes called a choke or coil.
In
Short For "in the circuit," in other words "active."
In-Line Console
A console with modules that have controls for all console sections
in one long strip.
In Port
A jack on a MIDI device or computer that will accept an incoming
data signal.
Infinite Baffle
A baffle so large that the sounds coming from one side do not reach
the other side.
Infinite Repeat
A function on some delay lines that establish enough feedback so
that the repeat echo will last forever, but not so much as to cause a
howling sound.
Information Bits
The bits in the digital signal that make up actual values or
commands being communicated as opposed to bits that are used for
checking & correcting data or other purposes.
Initialize
To prepare a digital storage medium (like a floppy disk) so that it
will accept and store digital information bits.
Input
1) The jack or physical location of where a device receives a
signal.
2) The signal being received by a device.
3) The action of receiving a signal by a device.
Input Impedance
The opposition to current flow by the first circuits of a device.
Input Monitor
A switch position and operational mode of the electronics of a tape
machine where the signal at output of the electronics will be the same
as the signal coming into the electronics. In this mode, the tape
machine's meter will read the input signal.
Input/Output Module
A set of controls, on one housing, for an in-line console that has
two channels (one for recording and one for monitoring) and has controls
for all console sections.
Input Overload
Sending too high of a signal level into a device so that the first
amplifier of the device overloads.
Insert
1) A punch in of the all of the tracks being recorded in a recording
session.
2) On Solid State Logic consoles, placing an outboard piece of gear in
the channel by patching and activating a switch.
Instrument Amplifier
A device that has a power amplifier and speaker in a case (or in
separate cases) to reproduce the signal put out by an electric
instrument (such as an electric guitar) and to allow the instrument to
be heard.
Instrument Out Direct
Feeding the output of an electric instrument (like an electric
guitar) to the recording console or tape recorder without using a
microphone.
Insulator
A substance such as glass, air, plastic, etc., that will (for all
practical purposes) not conduct electricity.
Integrated Circuit (IC)
A miniature circuit of many components in a small, sealed housing
with prongs to connect it into equipment.
Interface
Any device that allows one unit to work, drive or communicate with
another unit when they cannot do so by just feeding each other often
because the units are manufactured by different companies.
Intermodulation Distortion
Distortion caused by one signal beating with another signal and
producing frequencies that are both the sum and the difference of the
original frequencies.
Inverse Square Law
Simply stated, the fact that in an un-obstructed area (like an open
field) the sound pressure level will drop to half-pressure (-6 dB) every
time the distance to the sound source is doubled.
I/O
Short for "Input/Output' and referring to:
1) An in-line console module that contains controls for the input
section, output section and monitor section.
2) A module in electronic gear containing input and output amplifiers
for the device.
3) A digital port (connector) able to both receive digital data and
output digital data.
Isolation
A containing of the sound wave in a certain area so that it will not
leak into other areas and/or unintended mics.
Isolation Booth/ Isolation Room
A room that prevents loud sounds from other instruments from leaking
in: an isolation booth is usually a smaller room that could be used for
only one musician. |